Fisher & Paykel Dishwasher Noise: What's Normal, What's Not
Swift Appliance Solution
MON–SUN from 8:00AM to 8:00PM
(647) 846-7077

Fisher & Paykel Dishwasher Making Noise or Humming

By Andrew, appliance repair technician, 4+ years in the fieldUpdated November 17, 2026

Most of the sounds a Fisher & Paykel dishwasher makes are meant to be there. The drying fan running after the programme has finished, a high-pitched chirp while rinse aid is dispensed and odd noises from the water softener are all described as normal in the manual. The sound worth investigating is a motor that has turned loud or harsh, because Fisher & Paykel ties excessive motor noise to the filter plate and spray arm being out of place, or to the motor running without water.

Fisher & Paykel dishwasher noise at a glance
What it means
Usually the drying fan, rinse aid dispensing or the water softener — all normal; a loud motor points at the filter plate, spray arm or a dry pump
Check first
Has the programme just finished? Is the filter plate flush and the spray arm seated and free to turn?
Worth worrying about
A hard, grinding sound, or a motor note that changed suddenly
Labour
From $180
Parts
Priced after the diagnosis, before any work starts
Diagnostic visit
$79, waived when you go ahead with the repair
Where we work
Toronto, North York, York, East York, Etobicoke and Mississauga

Why is my Fisher & Paykel dishwasher making noise?

A DishDrawer is a shallow drawer with its own motor, pump and spray arm under the basket, so you sit much closer to the working parts than you would with a front-door machine. That is why owners notice sounds here that pass unnoticed elsewhere, and why most of the calls we take about noise turn out to be the machine behaving exactly as designed.

Three of those sounds are written into the manual as normal. The drying fan keeps running for a set time after a programme ends to help the dishes dry, and Fisher & Paykel says it stops on its own when that time is up or when you open the drawer — it may even start again when you close the drawer, without any new wash. Rinse aid dispensing produces what the manual calls unusual, high-pitched beeping, and that too needs no action. And if your machine has a water softener, the manual warns you may hear some unusual noises while it operates.

What is left is the motor. Fisher & Paykel lists excessive motor noise against two causes: the filter plate or spray arm being incorrectly placed, and no water in the motor area. Both make sense once you picture it — a spray arm that catches, or a pump pushing air instead of water, has to work harder and sounds like it.

What do different Fisher & Paykel dishwasher noises mean?

SoundWhat you noticeWhat it means
Fan after the washA steady fan once the programme has finished, sometimes restarting when you close the drawerNormal drying fan; it stops after a set time or when you open the drawer
High-pitched chirp mid-cycleA subtle, odd beeping partway through a programmeNormal: rinse aid being dispensed
Unfamiliar noises, hard water areaOccasional sounds with no pattern you can tie to the cycleNormal water softener operation on models that have one
Loud or laboured motorThe motor note is harsher than you remember, through the whole washFilter plate or spray arm out of position, or no water reaching the motor area
Rattle or knockIrregular, matches the spray arm sweeping roundLoading: a utensil or a tall item in the arm's path
GrindingA hard, scraping sound rather than a humSomething solid in the wash system; stop the programme and look before running it again
Fisher & Paykel dishwasher grinding or suddenly much louder? We can usually be out today.
Call (647) 846-7077 Text us

How to quiet a Fisher & Paykel dishwasher yourself

Work through these in order. The first two settle most of what we are called about.

  1. Decide whether the programme has finished. If the wash is over and all you hear is a fan, that is the drying fan and nothing is wrong. It stops by itself, and opening the drawer stops it sooner.
  2. Check the spray arm and filter plate. This is the one cause Fisher & Paykel names for excessive motor noise. Switch the dishwasher off at the power supply, lift the plastic grid, take out the drain filter, then check the spray arm sits properly and turns freely and that the filter plate is flush. Everything has to go back in place: the manual is explicit that the machine must be run with the filter plate, drain filter and spray arm correctly fitted.
  3. Look at how the drawer is loaded. A knocking that comes round in a rhythm is usually a utensil or a tall item clipping the spray arm. Rearrange so nothing stands in its sweep.
  4. Make sure water is actually getting in. The other listed cause is no water in the motor area, so confirm the supply tap is open and the inlet hose is not kinked. A pump running dry is loud and should not be left to do it.
  5. Stop at once for a grinding sound. Cancel the programme rather than letting it finish. Grinding means something solid is being pushed around down there, and a few more minutes of it can turn a clean-out into a pump replacement.

Call a technician if the motor is still loud with the spray arm and filter correctly fitted and water coming in, if the sound is grinding rather than humming, if the noise arrived suddenly rather than creeping up, or if the dishwasher beeps continuously — the manual treats continuous beeping as a fault rather than a noise complaint.

How loud should a Fisher & Paykel dishwasher be?

There is no single figure for the range: the decibel rating is quoted per model, and the one for yours is on its specification sheet rather than in the user guide. In practice the number matters less than the change. These machines are quiet by design, so owners tend to know their own dishwasher's sound well, and a note that has shifted — louder, harsher, or a hum where there was none — is more useful as a symptom than any rating.

Two sounds also depend on the programme rather than the machine. A longer or hotter cycle keeps the drying fan running afterwards, and an Eco programme moves water differently from a standard one. If the noise only appears on one setting, that is worth noting before anyone takes the drawer apart.

What we see on Fisher & Paykel dishwasher noise calls

Where
Toronto, North York, York, East York, Etobicoke and Mississauga
Machine
Fisher & Paykel dishwashers, including DishDrawer models
Technician
Andrew, appliance repair technician, 4+ years in the field
“When a Fisher & Paykel dishwasher is making noise, the first thing I do is lift the filter and turn the spray arm by hand, because a loud motor is far more often something sitting wrong than something broken.”— Andrew, our technician on these calls

Do you fix Fisher & Paykel dishwashers in my area?

Yes. We repair Fisher & Paykel dishwashers that have turned noisy in Toronto, North York, York, East York, Etobicoke and Mississauga, and across the rest of the GTA and Simcoe County: 29 areas, same day in most of them, seven days a week, with no travel surcharge.

Still loud with everything back in place? Book a technician for today.
Call (647) 846-7077

Questions we get about noisy Fisher & Paykel dishwashers

Why is my Fisher & Paykel DishDrawer humming?

A hum is the motor, and Fisher & Paykel names two causes for excessive motor noise: the filter plate or spray arm being incorrectly placed, and no water in the motor area. Switch the power off, check the spray arm sits properly and turns freely and that the filter plate is flush, then confirm the supply tap is open and the inlet hose is not kinked. A pump running dry should not be left running.

Is it normal for a Fisher & Paykel dishwasher to make noise after the cycle finishes?

Yes. The manual describes the drying fan continuing for a set period after a programme ends to help with drying, and says no action is required: it stops when that time is up or when you open the drawer. It may also start again when you close the drawer without any new wash, which is listed as normal too.

What does a grinding noise in a Fisher & Paykel dishwasher mean?

Grinding is a harder, scraping sound rather than a hum, and it usually means something solid is being moved around in the wash system. Cancel the programme instead of letting it finish, then switch the power off and check the spray arm and the area under the drain filter before running it again. If the sound comes back with everything correctly fitted, it needs a diagnosis rather than another cycle.

How much does it cost to fix a noisy Fisher & Paykel dishwasher?

Labour starts at $180. The part depends on what the diagnosis finds, so we price it once we know what failed. The $79 diagnostic is waived when you go ahead.

Swift Appliance Solution
×
MON–SUN from 8:00AM to 8:00PM
(647) 846-7077
Request a callback
Get a call in 5 minutes

Leave your number and our dispatcher will call you back right away — Mon–Sun, 8 AM to 8 PM.

✓ No spam. By submitting you agree to our Privacy Policy.
or call us now: (647) 846-7077
✓
We're dialing!
Expect our call within 5 minutes.