Blomberg Washing Machine Not Working or Won't Start
When a Blomberg washing machine won't start, it is usually waiting for something it needs before it can run: power at the outlet, a door that is properly latched, a free control panel, or water from the taps. The child lock and a Delayed Start that is still counting down catch out a lot of people. When all of those check out and the washer still does nothing, the fault is in the door lock, a button or the control board.
- What it means
- One of the conditions the washer checks before a cycle is missing: power, a latched door, water or an unlocked panel
- Check first
- The breaker, the child lock, the Delayed Start symbol and whether the door is fully closed
- Dark panel
- A power question first: the outlet, the breaker, the plug
- Labour
- From $180
- Parts
- Priced after the diagnosis, before any work starts
- Diagnostic visit
- $79, waived when you go ahead with the repair
- Where we work
- Toronto, North York, York, East York, Etobicoke and Mississauga
Why is my Blomberg washing machine not starting?
A Blomberg front loader runs a short list of checks before it starts a programme, and if any of them fails it simply does not start. When you press Start / Pause / Cancel, the machine locks the loading door and shows the Door Locked symbol. If the door cannot lock, the cycle does not go any further.
The control panel can also be blocked on purpose. With the child lock on, Blomberg's manual says the machine will not let you select a new programme, and pressing any button only brings the child lock message back to the display. A Delayed Start does something similar: the washer accepts the programme but waits, counting down for up to 24 hours on many models, before the drum moves.
Supply matters too. The machine waits until it has taken in enough water, and the manual notes that if the voltage drops, a programme can stop shortly after starting and resume once the voltage is back to normal. So a washer that seems dead is often a washer that is waiting.
What stops a Blomberg washer from starting?
| Cause | What you notice | What fixes it |
|---|---|---|
| Child lock on | The display lights up, but buttons do nothing and the child lock message appears | Switching the child lock off as your manual describes |
| Delayed Start set | A countdown on the display, the Delayed Start symbol lit, the drum still | Cancelling the delay or letting the countdown finish |
| Door not latched | The Door Locked symbol never appears; laundry may be caught in the door seal | Closing the door firmly, or replacing a worn door lock |
| No power | The panel is completely dark: no lights, no tones | Resetting the breaker or fixing the outlet; if power is there, diagnosing the switch and board |
| No water coming in | The No Water symbol, or the programme sits without filling | Opening the taps fully, straightening the inlet hose, cleaning the inlet filter |
| Control board or button fault | The panel lights up, the child lock is off, but Start does nothing | Diagnosing the button and the control board; the least common cause |
How to fix a Blomberg washer that won't start yourself
Most of these checks take a minute and need no tools. Work through them in order:
- Check the power. If the panel is dark, look at the breaker for the laundry outlet and make sure the plug is pushed fully into a wall socket, not an extension cord. Plug a lamp into the same outlet to see whether it is live.
- Switch the washer off, wait a few minutes, switch it back on. This clears a lot of one-off hiccups, and a programme that was interrupted will often carry on.
- Turn off the child lock. If the buttons do nothing, it is probably on. On many Blomberg models you hold two of the function buttons for three seconds; your manual shows which two.
- Look for a Delayed Start. If the display is counting down and the Delayed Start symbol is lit, the washer is doing what it was told. Cancel the delay or set it back to zero.
- Close the door firmly. Check that no sleeve or sock is trapped in the rubber seal, then shut the door until it clicks.
- Open both taps fully and check the inlet hose. A kinked hose or a closed tap leaves the machine waiting for water. If the No Water symbol is on, clean the filter where the hose meets the machine.
- Reset the programme. Blomberg's troubleshooting section says that if a programme cannot be started or selected, you press and hold Start / Pause / Cancel for three seconds. Then choose the programme again and press Start.
Call a technician if the panel stays dark although the outlet works, if the Door Locked symbol never appears with the door shut, if the buttons stay dead with the child lock off, or if the taps are open and the filter is clean but the washer still will not fill.
What we see on Blomberg washer no-start calls
- Where
- Toronto, North York, York, East York, Etobicoke and Mississauga
- Machine
- Blomberg front-load washers, including compact models
- Technician
- Andrew, appliance repair technician, 4+ years in the field
“When a Blomberg washer won't start, the first thing I check is whether the panel lights up at all: a dark panel and a panel that ignores the Start button point to very different parts.”— Andrew, our technician on these calls
Do you fix Blomberg washers in my area?
Yes. We repair Blomberg washers that will not start in Toronto, North York, York, East York, Etobicoke and Mississauga, and across the rest of the GTA and Simcoe County: 29 areas, same day in most of them, seven days a week, with no travel surcharge.
Questions we get about Blomberg washers that won't start
Why won't my Blomberg washing machine turn on at all?
If the panel is completely dark, it is a power question first: check the breaker, the plug and the outlet with a lamp. If the outlet is live and the panel still stays dark, the fault is inside the washer, in the On / Off switch, the wiring or the control board, and needs a technician.
Why is my Blomberg washer not starting when the lights come on?
The most common reasons are the child lock, a Delayed Start that is still counting down, or a door that is not fully latched. Switch the child lock off, cancel any delay, close the door firmly and press Start / Pause / Cancel again.
How do I reset a Blomberg washer that is not working?
Blomberg's manual says that if a programme cannot be started or selected, you press and hold Start / Pause / Cancel for three seconds. You can also switch the machine off, wait a few minutes and switch it back on, then select the programme again.
How much does it cost to fix a Blomberg washing machine that will not start?
Labour starts at $180. The part depends on what the diagnosis finds, so we price it once we know what failed. The $79 diagnostic is waived when you go ahead.